Opens in a new tab

AES E-Library

← Back to search

Journal Article

An Ultralow-Noise Phantom-Powered Microphone Amplifier

Authors: Spinelli, Enrique M.

Journal of the Audio Engineering Society · Volume 74 · Issue 11 · pp. 877–886 · November 2026

Abstract

Low-noise amplifier design inherently conflicts with low power consumption. This trade-off becomes particularly critical in phantom-powered audio equipment, where the available power is severely limited and must be carefully preserved. An optimized design for achieving ultralow-noise amplifiers with a noise floor below 1 nV/√Hz while operating under phantom power is presented. It is shown that, when the total collector current is limited, paralleling N transistors to reduce amplifier noise is effective only up to a certain number of devices, beyond which increasing N no longer improves noise performance. As an example, a double-balanced microphone amplifier was designed, built, and tested. It exhibits an input-referred noise density of 0.6 nV/√Hz over the 20 Hz–20 kHz bandwidth (−141 dBV or −139 dBu) while consuming less than 8.5 mA. A noise floor level of 0.55 nV/√Hz (−140 dBu) can be achieved by accepting a phantom current of 9.5 mA. A detailed circuit analysis and design equations are provided to adapt the circuit to different requirements and design constraints.

Details

Publication
Journal of the Audio Engineering Society
Volume
74
Issue
11
Pages
877–886
Publication date
November 10, 2026
Affiliation
Institute of Research in Electronics, Control, and Signal Processing LEICI, Faculty of Engineering, National University of La Plata, Argentina; National Scientific and Technical Research Council (CONICET), Argentina (See document for exact affiliation information.)
Type
Journal Article

Save to list