M. Sekiya and M. Otala, “Load Handling Capability of Commercial Power Amplifiers,” in Proc. AES Convention 78, May 1985, pp. 2237:1-8. [Online]. Available: https://aes.org/publications/elibrary-page/?id=11518
Sekiya M, Otala M. Load Handling Capability of Commercial Power Amplifiers. In: AES Convention 78. Audio Engineering Society; 1985.pp. 2237:1-8. Available from: https://aes.org/publications/elibrary-page/?id=11518
@inproceedings{Sekiya1985_11518,
author = {Sekiya, Mamoru and Otala, Matti},
title = {{Load Handling Capability of Commercial Power Amplifiers}},
booktitle = {AES Convention 78},
pages = {2237:1-8},
url = {https://aes.org/publications/elibrary-page/?id=11518},
year = {1985},
month = may,
publisher = {Audio Engineering Society}
}
TY - CPAPER
TI - Load Handling Capability of Commercial Power Amplifiers
AU - Sekiya, Mamoru
AU - Otala, Matti
T2 - AES Convention 78
SP - 1
EP - 8
M1 - Paper 2237
PY - 1985
DA - 1985/05/06
UR - https://aes.org/publications/elibrary-page/?id=11518
PB - Audio Engineering Society
LA - en
AB - Five modern power amplifiers were tested using a complex load with an impedance range of 2 to 8 ohms and a phase angle range of -60 to +60 degrees. Output power was increased at each load setting until the amplifier produced 1% THD at 1kHz. This was considered as the distortion-limited maximum output power of the amplifier. The results are presented in three-dimensional plots and show that only few amplifiers can handle the normally encountered complex loudspeaker impedances without excessive distortion. Also, limiting of output power to a fraction of the nominal power is reported for some of the amplifiers, when the load phase angle exceeds a few tens of degrees.
ER -